JVC CA-MXG500, SP-MXG500 manual Using Recording Timer, Press CLOCK/TIMER again

Continued

6 Select the preset station number.

Press 4 or ¢ to select the preset station number, then press SET.

The unit enters volume setting mode.

SET

7 Press 4or ¢ to set the volume level.

• You can select the volume level from VOL MIN, VOL 1 — VOL 30, and VOL MAX.

8	Press SET to complete the Daily			SET
	Timer setting.
	The DAILY (daily timer) indicator stops
	flashing and remains lit. The settings you have
	done are shown on the display in sequence for your
	confirmation.
9	Press	STANDBY/ON to	STANDBY
				STANDBY/ON

turn off the unit (on standby) if you have set the Daily Timer with the unit turned on.

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

To turn on or off Daily Timer after its setting is done

1 Press CLOCK/TIMER repeatedly until	CLOCK
	/TIMER
“DAILY” appears on the display.
2 To turn off the Daily Timer, press
CANCEL/DEMO.	/DEMO
The DAILY (daily timer) indicator goes off
	CANCEL
from the display (“OFF” appears for a while).
The Daily Timer is canceled, but the setting
for the Daily Timer remains in memory until
you change it.
To turn on the Daily Timer, press SET.	SET
The DAILY (daily timer) indicator lights up
on the display. The settings you have done are
shown on the display in sequence for your
confirmation.

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the unit is on or off.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “VOL MIN,” and starts recording when the on-time comes (the indicator flashes while the timer is operating). Then, when the off-time comes, the unit automatically turns off (stands by).

Recording Timer works only once, but the timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

•If you have made a mistake while setting the timer, press CANCEL/DEMO. (However, this does not always work. If CANCEL/DEMO does not work, press CLOCK/TIMER repeatedly and start from step 2 again.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER repeatedly	CLOCK
	/TIMER
until “REC” appears on the display.

indicator lights up and the REC (recording timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY	ON TIME		REC
	(Daily Timer)
Canceled	CLOCK	ON TIME

(See page 9.) (Recording Timer)

3 Press CLOCK/TIMER again.	/TIMER
	CLOCK

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

– 20 –