JVC CA-MXG500, SP-MXG500 manual Mises en garde, précautions et indications diverses

Page 2

Warnings, Cautions and Others

Mises en garde, précautions et indications diverses

 

 

CAUTION

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK.

 

DO NOT REMOVE COVER (OR BACK)

 

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

ATTENTION

Afin d’éviter tout risque d’électrocution, d’incendie, etc.:

1.Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil.

2.Ne pas exposer l’appareil à la pluie ni à l’humidité.

Caution –– STANDBY/ON switch!

Disconnect the mains plug to shut the power off completely.

The STANDBY/ON switch in any position does not disconnect the mains line. The power can be remote control- led.

Attention –– Commutateur STANDBY/ON!

Déconnecter la fiche de secteur pour couper complètement

le courant. Le commutateur STANDBY/ON ne coupe

jamais complètement la ligne de secteur, quelle que soit sa position. Le courant peut être télécommandé.

1.CLASS 1 LASER PRODUCT

2.DANGER: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3.CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel.

1.PRODUIT LASER CLASSE 1

2.ATTENTION: Radiation laser invisible quand l'appareil est ouvert ou que le verrouillage est en panne ou désactivé. Eviter une exposition directe au rayon.

3.ATTENTION: Ne pas ouvrir le couvercle du dessus. Il n'y a aucune pièce utilisable à l'intérieur. Laisser à un personnel qualifié le soin de réparer votre appareil.

G-1

Image 2
Contents Instructions Mises en garde, précautions et indications diverses For Canada/pour le Canada About This Manual PrecautionsIntroduction Contents Become familiar with the buttons and controls on your unit Location of the Buttons and ControlsFront Panel See pages in the parentheses for details Front PanelDisplay window 0Carrousel open/close button 12, 13Remote Control Remote ControlUnpacking Connecting AntennasGetting Started FM antennaAM antenna Connecting SpeakersRelease the finger from the clamp On the unit only Connecting Other EquipmentCancelling the Display Demonstration To connect an analog componentOn the unit only Press CLOCK/TIMER Turning On or Off the PowerSetting the Clock Common OperationsReinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the Sound ModesTuning in a Preset Station Tuning in a StationPresetting Stations Listening to the RadioPlaying Back CDs-All Disc and One Disc Playing Back CDsLoading CDs Load CDs Basic CD OperationsPress one of the disc number Buttons CD1, CD2 or CD3 Press one of the disc number Buttons CD1, CD2 or CD3 youPrograming the Playing Order of the Tracks --Program Play Press one of the disc number Buttons CD1, CD2, and CD3 toProhibiting Disc Ejection--Tray Lock Playing at Random--Random PlayRepeating Tracks or CDs--Repeat Play Press Random so that Random M Random appears on the displayPress Eject 0 for the deck you want to use Playing Back TapesPlaying Back a Tape Close the cassette holder gentlyPress REC START/STOP RecordingRecording a Tape on Deck B To keep the best recording and playback sound qualityOn the unit only Press Tape 3, then Dubbing TapesCD Synchronized Recording Press DubbingUsing the Timers Using Daily TimerUsing Recording Timer Press CLOCK/TIMER againOn the remote control only Press Sleep Using Sleep TimerTimer Priority Handling discs MaintenanceCleaning the unit Handling cassette tapesTroubleshooting SymptomSpecifications Authorized Service Centers Limited Warranty Memo Memo 0102KSMMDWSAM