Congratulations on your purchase of a quality Orion mount. Your new Atlas
These instructions will help you set up and properly use your equatorial mount. Please read them over thoroughly before getting started.
Table of Contents
1. | Unpacking | . 3 |
2. | Parts List | 3 |
3. | Assembly | 3 |
4. | Attaching a Telescope | 4 |
5.Balancing a Telescope . . . . . . . . . 4
6.Setting Up and Using the Equatorial Mount . . 5
7.The Atlas EQ-G Dual Axis Hand Controller . 8
8.The Atlas EQ-G GoTo Hand Controller . . 10
9.Specifications . . . . . . . . . . . . 19
10.Appendices . . . . . . . . . . . . 21
1. Unpacking
The entire mount will arrive in three boxes, one containing the tripod, one containing the equatorial mount, and one con- taining the hand controller. Be careful unpacking the boxes. We recommend keeping the boxes and original packaging. In the event that the mount needs to be shipped to another location, or returned to Orion for warranty repair, having the proper packaging will ensure that your mount will survive the journey intact.
Make sure all the parts in the Parts List are present. Be sure to check the box carefully, as some parts are small. If anything appears to be missing or broken, immediate- ly call Orion Customer Support
Box 3: Dual-Axis Hand Controller
1
2Nylon
1 Wire clip
If you’ve purchased the #7947 GoTo hand controller:
Box 3: GoTo Hand Controller
1 GoTo hand controller
1GoTo hand controller cable for Sirius
1GoTo hand controller cable for Atlas
1GoTo hand controller bracket
1Computer interface cable
1Wire clip
3.Assembly
Refer to Figure 1 as needed during the assembly process.
1.Stand the tripod legs upright and spread the legs out as far as they will go. Make certain that the leg lock levers are tightened. Keep the tripod legs at their shortest (fully retracted) length, for now; you can extend them to a more desirable length later, after the mount is fully assembled.
2.Place the base of the equatorial mount onto the tripod head. Orient the equatorial mount so that the post on the tripod head lines up with the azimuth adjustment knobs on the equatorial mount (Figure 2). You may need to loosen the azimuth adjustment knobs on the equatorial mount in order to fit the mount onto the tripod head.
2. Parts List
Box 1: Tripod
Qty. Item
1Tripod
2Counterweights (11lbs. each)
1Tripod center support tray
Box 2: Equatorial Mount
1 Equatorial mount
1Tube ring mounting plate
112V DC Power cable
If you’ve purchased the #7945 Dual-Axis hand controller:
Azimuth adjustment knobs
Post
Figure 2. Orient the equatorial head so that the post on the tripod lines up with the azimuth adjustment knobs on the equatorial mount.
3