JVC SP-MXG500, CA-MXG500 Maintenance, Cleaning the unit, Handling discs, Handling cassette tapes

Page 25

Maintenance

To get the best performance of the unit, keep your discs, tapes, and mechanism clean.

Cleaning the unit

•Stains on the unit

Should be wiped off with a soft cloth. If the unit is heavily stained, wipe it with a cloth soaked in water-diluted neutral detergent and wrung well, then wipe clean with a dry cloth.

•Avoid the following since they may cause damage to the unit.

-DO NOT wipe it with a hard cloth.

-DO NOT wipe it strong.

-DO NOT wipe it with thinner or benzine.

-DO NOT apply any volatile substance such as insecticides to it.

-DO NOT allow any rubber or plastic to remain in contact with it for a long time.

Handling discs

• Remove the disc from its case by holding it at the edge while pressing the center hole lightly.

• Do not touch the shiny surface of the disc, or bend the disc.

• Put the disc back in its case after use to prevent warping.

• Be careful not to scratch the surface of the disc when placing it back in its case.

• Avoid exposure to direct sunlight, temperature extremes, and moisture.

Handling cassette tapes

• If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating.

• If the tape is loose, it may get stretched, cut, or caught in the cassette.

•Be careful not to touch the tape surface.

•Avoid the following places to store the tape:

— In dusty places

— In direct sunlight or heat

—In moist areas

—Near a magnet

To clean the disc

Wipe the disc with a soft cloth in a straight line from center to edge.

DO NOT use any solvent—such as conventional record cleaner, spray, thinner, or benzine—to clean the disc.

– 22 –

Image 25

Contents Instructions Mises en garde, précautions et indications diverses For Canada/pour le Canada Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsBecome familiar with the buttons and controls on your unit Display window Front PanelSee pages in the parentheses for details 0Carrousel open/close button 12, 13Remote Control Remote ControlGetting Started Connecting AntennasUnpacking FM antennaRelease the finger from the clamp Connecting SpeakersAM antenna Cancelling the Display Demonstration Connecting Other EquipmentOn the unit only To connect an analog componentSetting the Clock Turning On or Off the PowerOn the unit only Press CLOCK/TIMER Common OperationsTo turn down the volume level temporarily Adjusting the VolumeReinforcing the Bass Sound Selecting the Sound ModesPresetting Stations Tuning in a StationTuning in a Preset Station Listening to the RadioLoading CDs Playing Back CDsPlaying Back CDs-All Disc and One Disc Press one of the disc number Buttons CD1, CD2 or CD3 Basic CD OperationsLoad CDs Press one of the disc number Buttons CD1, CD2 or CD3 youPress one of the disc number Buttons CD1, CD2, and CD3 to Programing the Playing Order of the Tracks --Program PlayRepeating Tracks or CDs--Repeat Play Playing at Random--Random PlayProhibiting Disc Ejection--Tray Lock Press Random so that Random M Random appears on the displayPlaying Back a Tape Playing Back TapesPress Eject 0 for the deck you want to use Close the cassette holder gentlyRecording a Tape on Deck B RecordingPress REC START/STOP To keep the best recording and playback sound qualityCD Synchronized Recording Dubbing TapesOn the unit only Press Tape 3, then Press DubbingUsing Daily Timer Using the TimersPress CLOCK/TIMER again Using Recording TimerTimer Priority Using Sleep TimerOn the remote control only Press Sleep Cleaning the unit MaintenanceHandling discs Handling cassette tapesSymptom TroubleshootingSpecifications Authorized Service Centers Limited Warranty Memo Memo 0102KSMMDWSAM