Route the Cable | Precor S3.25 specification

S3.25 Leg Press Option Assembly Instructions

5. Route the Cable

As you route the Cable through the pulleys on the Leg Press Option, wrench tighten the fasteners on each pulley as you go. Make sure that the Cable slides freely along the pulley (and beneath the cable retainer). Make sure that you are using the correct Cable before you tighten the fasteners.

A. Attach the barrel end of Cable 40538-101 to the
	Seat Frame using
	one 4-inch bolt
	one washer
	one locknut
	Wrench tighten so that the barrel end of the Cable
	rotates freely.
B.	Loosen all the fasteners that attach the pulleys to
	the Seat Frame.
C.	Push the Pivot Arm forward so that the pulleys are
	easily accessible.
D. Route the Cable around the pulley inside the Pivot
	Arm Cover that is on the same side as the barrel
	end of the Cable (see illustration). The Cable
	should slide along the pulley beneath the cable
	retainer. Wrench tighten this pulley’s fasteners.
E. You may need to slide the bolt out of the Pivot Arm
	Cover to wrap the Cable around the pulley.

Push the Pivot	C
Arm forward

1 - 4" bolt

1 - washer A

1 - locknut

Loosen the pulley

B fasteners

Pivot

Arm

Pivot Arm

Seat Frame

Cable 40538-101

F.	Continue to route the Cable around the pulleys as
	shown in the illustration. Make sure that the Cable
	slides freely along the pulleys (and beneath the
	cable retainers) before you wrench tighten their
	fasteners.
G. Wrap the Cable around the 4½-inch pulley (and
	beneath its cable retainer) that is attached to the
	Cross Brace. Wrench tighten.

Note: The Seat Pad is not shown.

1 2 3 4

Wrap the Cable around the G 4½" pulley attached to the

Cross Brace

Step 5. Route the Cable

page 12