S3.25 Leg Press Option Assembly Instructions
4 Adjustments
After the Leg Press Option is assembled, you should check the Cables for proper tension. These are some obvious signs that cable problems exist:
✔Excess slack exists in the Cable.
✔The Top Cap Weight does not rest squarely on the Weight Stack.
✔The Cable rubs the inside edges of the pulleys.
CAUTION:Take the time to perform the following steps. If the Cables do not have
the proper tension, you could damage the machine and void the Precor Limited Warranty.
Note: To adjust the Selector Stem, refer to the S3.25 Assembly and Maintenance Guide.
1. Stretch the Cable
A.Sometimes a new cable must be stretched so that the Top Cap Weight rests on the Weight Stack. To lengthen the Cable, insert the Weight Pin at a comfortable weight level.
B.Push up on the Chest Press Arms, and then slowly lower them.
C.Make sure the Top Cap Weight rests squarely on the Weight Stack. If it does, no more adjustments are needed, and the Leg Press Option is ready to use. If the Top Cap Weight does not rest on the Top Weight then further adjustments are needed. Continue with steps 2 and 3.
|
|
| A |
|
|
|
|
| Top Cap Weight |
|
|
|
|
| Top Weight |
|
|
|
|
| Weight Pin |
|
|
|
|
| B | C |
|
|
|
|
|
| |
|
| Chest Press Arms | Top Cap |
| |
|
|
|
| Weight |
|
1 | 2 | 3 | 4 | 5 | 6 |
Adjustments
page 16