Perreaux SX60m manual For more information on line input specifications, please refer to Chapter

Page 12
For more information on line input specifications, please refer to Chapter 11.

Note:

Note:

Caution!

For more information on line input specifications, please refer to Chapter 11.

Please refer to the operating manual of your preamplifier to verify that the pin assignments of the balanced output connectors correspond to the SX60m balanced inputs. In the event that they are not compatible, the interconnecting cable will need to be altered to suit.

Manual background Balanced Output

Balanced Output to other amplifiers (e.g. bi-amping), accepts a standard balanced connector (XLR).

The pin assignments of the balanced XLR output connectors are as follows:

Pin 1: Signal ground

Pin 2: Signal + (non-inverting)

Pin 3: Signal – (inverting)

Shield ground: Chassis ground

For more information on line output specifications, please refer to Chapter 11.

Please refer to the operating manual of your amplifier to verify that the pin assignments of the balanced input connectors correspond to the SX60m balanced outputs. In the event that they are not compatible, the interconnecting cable will need to be altered to suit.

Manual background Speaker Binding Posts

Binding posts are clearly marked and colour coded RED Positive

(+)and BLACK Negative (-). This polarity must be observed when connecting loudspeakers, i.e. positive terminal of the SX60m to the positive terminal of the loudspeaker and negative terminal of the SX60m to the negative terminal of the loudspeaker.

Never connect either of the output terminals to ground.

Never connect the amplifier’s output terminals to any device other than a loudspeaker.

Please do not short-circuit the amplifier’s output terminals.

Never connect the output of one amplifier to the output terminals of another amplifier.

Do not over-tighten the binding posts on your amplifier.

11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 60W Mono-AuralPower Amplifier SX60mPage This page has intentionally been left blank Introducing the Perreaux Silhouette SeriesiiImportant Safety Instructions Table of Contents 1Unpacking and Placement Instant Install Insert the power cord supplied into the rear of the SX60m and into the wall. Switch on the socket at the wall and turn on the power of the SX60m by setting the power switch down Power LED Front Panel FunctionsRear Panel Functions For more information on line input specifications, please refer to Chapter The serial number is unique to your SX60m. Please record this number and store it in a safe place. For any service related enquiry, please be prepared to quote the product serial number to Perreaux personnel or their service representative 5Special Design Philosophies John Pawson writes Special Design Features The SX60m features a 98VA toroidal mains transformer directly soldered to the PCB, Wima and Elna capacitors, highest quality Zobel network and customized internal heat sink solution. The PCB is double-sidedand constructed from the highest quality fibreglass base stock featuring 2oz copper Care and Maintenance Warranty Information Extended Warranty Registration Form 3 Year Extended Warranty FormS I L H O U E T T E S X 6 0 m Troubleshooting Guide Check that the input and output RCA sockets and binding posts on the rear of the SX60m are free from corrosion 11Specifications IEC AC mains input receptacle Mains Input Voltage The Input Sensitivity figure indicates the input voltage required to achieve “rated” output 60WRMS into 8Ω Physical Dimensions Contact Details Installation Notes
Top Page Image Contents