ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Note: The underside of the treadmill walking belt is coated with
Assembly requires a phillips screwdriver | and the included allen wrench . |
1.With the help of a second person, carefully raise the Uprights (65) to a vertical position.
Have the second person hold the console assembly near the Uprights (65) as shown. Look under the console as- sembly and locate the Console Wire Harness (71) and the TV cable.
Cut the plastic ties securing the Upright Wire Harness (85) and the Upright TV Cable (100) to the Uprights (65). Connect the Upright TV Cable to the TV cable in the con- sole assembly. Connect the Upright Wire Harness to the Console Wire Harness (71). Make sure to connect the connectors properly (see the inset drawing). The con- nectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
2.Insert the slack in the Wire Harnesses (71, 85) and the TV cable into the Uprights (65).
Set the console assembly on the Uprights (65). While a second person holds the console assembly, attach the console assembly with four 1” Console Bolts (133) and four Console Washers (69) as shown. Firmly tighten the Console Bolts.
1 | Console |
|
|
| |
| Assembly |
|
71 | 85 | TV Cable |
| 65 | 100 |
| 71 | 65 |
|
| |
| 85 |
|
2 | Console |
|
| Assembly |
|
| 71, 85 |
|
69 | 69 |
133 | 133 |
65 | 65 |
69
133
7