HOW TO TURN ON THE POWER
1 Plug in the power cord (see page 8).
2 | Locate the on/off |
|
|
|
switch near the power |
|
|
| |
| On |
| ||
|
|
| ||
| cord. Move the on/off |
|
| |
|
| Position |
| |
| switch to the on posi- |
|
| |
|
|
|
| |
| tion. |
|
|
|
Stand on the foot rails of the treadmill. Find the clip
3 attached to the key (see the drawing on page 9)
and slide the clip onto the waistband of your clothes. Next, insert the key into the console. After a moment, the displays and various indicators will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the con- sole, adjust the position of the clip.
HOW TO USE THE MANUAL MODE
1 Insert the key fully into the console.
See HOW TO TURN ON THE POWER above.
2 Select the manual mode.
When the key is in- serted, the manual mode will be selected and the Manual indica-
tor will light. If a pro- gram has been
selected, press the Program button repeatedly to reselect the manual mode.
Press the Start button or the Speed ▲ button to
3 start the walking belt.
A moment after the but- ton is pressed, the walking belt will begin to move at 1 mph. Hold
the handrails and begin walking. As you exer-
cise, change the speed of the walking belt as de- sired by pressing the Speed ▼ and ▲ buttons.
Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. To change the speed setting quickly, press the Quick Speed buttons. Note: The console can display speed and distance in either miles or kilometers. For simplicity, all instructions in this section refer to miles.
To stop the walking belt, press the Stop button. The Time/Segment Time display will begin to flash. To restart the walking belt, press the Start button or the Speed ▲ button.
During the first few minutes that the treadmill is used, inspect the alignment of the walking belt, and align it if necessary (see page 24).
4 Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the Incline buttons. Each time a button is pressed, the
incline will change by 0.5%. Note: After the but-
tons are pressed, it may take a moment for the treadmill to reach the selected incline setting.
5 Follow your progress with the displays.
The program display—
When the manual mode or the iFIT.com mode is selected, the program display will show a track representing 1/4 mile. As
you exercise, the indica-
tors around the track will light in sequence until you have completed 1/4 mile. A new lap will then begin.
Distance/Incline/
Laps
run, the incline level of the treadmill, and the
number of
10