ProForm PFTL49100 user manual Assembly, Cutters A rubber mallet

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials; do not

dispose of the packing materials until assembly is completed. In addition to the included allen wrench			,
assembly requires a phillips screwdriver		, two adjustable wrenches	, wire
cutters	, and a rubber mallet	.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

		Handrail Bolt (91)Ð2
Handrail Washer (92)Ð2	Small Screw (13)Ð2
			Screw (33)Ð4
Handrail Nut (93)Ð2	Extension Leg	Rack Washer
	Screw (53)Ð2	(41)Ð2	Rack Bolt (89)Ð2

1.With the help of a second person, carefully raise the Uprights (11) until the treadmill is in the position shown.

1

11

2. Insert one of the Extension Legs (34) into the treadmill	2
as shown. Make sure that the Base Pad (40) is on the
	11
indicated side. Note: It may be helpful to tip the Uprights
[11] in the direction shown by the arrow as you insert
the Extension Leg. To fully insert the Extension Leg, it
may be necessary to tap it with a mallet.	53
Attach the Extension Leg (34) with an Extension Leg
Screw (53). Be sure to push on the head of the
Extension Leg Screw while tightening it.	34
Attach the other Extension Leg (34) in the same way.	40

5