ProForm PFTL58007.0 user manual Problem The walking belt slows when walked on

Page 22

Remove the key from the console and UNPLUG THE POWER CORD. Remove the three #8 x 3/4" Screws (12) and carefully pivot the Hood (61) off.

Locate the Reed Switch (71) and the Magnet (50) on the left side of the Pulley (51). Turn the Pulley until the Magnet is aligned with the Reed Switch.

Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If neces- sary, loosen the 3/4" Reed Switch Screw (15), move the Reed Switch slightly, and then retighten the Screw. Reattach the Hood (not shown). If nec- essary, tip down the Uprights (not shown), reattach the #8 x 2" Screws (not shown), and raise the Uprights. Run the treadmill for a few minutes to check for a correct speed reading.

12

61

1/8 in.

15

50

71

51

Top

View

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 12.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.

b

2–3 in.

 

Rear Roller Bolts

c. If the walking belt still slows when walked on, see the front cover of this manual.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Call TOLL-FREE QUESTIONS?Please do not Contact On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Hardware may be includedNut the Wheel must turn freely. Discard Make sure that the power cord is unpluggedDo not fully fold the Frame yet See the inset drawing. Tie the long tieFully tighten the Bolts yet Make sure the Upright Wire 38 is notNot fully fold the Frame yet Firmly tighten the Bolts Star Washers 9. Firmly tighten the BoltsStart all the Screws before tightening any of them Pull on the sleeve to make sure that it is locked into placeRaise the Frame 56 to the position shown HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired HOW to USE a Classic Workout Select a classic workoutHOW to USE the Weight Loss Center Select a weight loss workoutInformation Mode HOW to USE the Stereo Sound SystemConnector is fully plugged Optional Chest Pulse SensorHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Page Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches R1007A Qty DescriptionQty Exploded Drawing A-Model No. PFTL58007.0 R1007A Exploded Drawing B-Model No. PFTL58007.0 R1007A Exploded Drawing C-Model No. PFTL58007.0 Exploded Drawing D-Model No. PFTL58007.0 R1007A Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT

PFTL58007.0 specifications

The ProForm PFTL58007.0 is a versatile treadmill designed to cater to both novice and seasoned runners seeking an efficient and effective workout solution. This model stands out in the crowded fitness market, boasting a range of features and technologies that enhance the overall user experience.

One of the most notable aspects of the PFTL58007.0 is its powerful 2.5 CHP motor, which ensures a smooth and reliable performance across various workout intensities. This motor allows for speeds ranging from 0 to 10 mph, accommodating different fitness levels and preferences. Additionally, the treadmill features a 10% incline option, providing users with an added challenge to boost their cardiovascular workout and engage more muscle groups during their runs.

Another key feature of the ProForm PFTL58007.0 is its spacious running surface. With a generous 20” x 55” tread belt, users can enjoy a comfortable and safe running experience without feeling constrained. The cushioned running deck is designed to reduce impact on joints, making it an excellent choice for those with a history of injuries or for individuals looking to prevent them.

In terms of technology, the ProForm PFTL58007.0 integrates with iFit, a subscription-based fitness platform that offers a wide variety of interactive workouts led by personal trainers. This feature allows users to experience global workouts and studio sessions, providing an engaging and motivating environment to reach fitness goals. The treadmill also includes a 5” display that tracks essential stats such as speed, distance, time, and calories burned, giving users immediate feedback during their workout.

Convenience features abound in the ProForm PFTL58007.0, including built-in speakers, an audio jack for media devices, and quick-access controls for speed and incline. The space-saver design allows the treadmill to fold up easily, making it ideal for those with limited space.

Overall, the ProForm PFTL58007.0 is a well-rounded treadmill that combines performance, comfort, and advanced technology. With its robust motor, adjustable incline, spacious running surface, and iFit compatibility, it is an excellent choice for anyone looking to enhance their fitness journey from the comfort of home.
Top Page Image Contents