ProForm PFTL66010.0 user manual Sure that the wire tie does not fall into, Pinch the Upright Wire

7. Insert the bracket on the Left Handrail (82) into	7
the Left Upright (84).				102
Insert the Upright Wire (87) several inches
downward into the Right Upright (85); make	9
sure that the wire tie does not fall into the			Welded
Right Upright. Then, insert the Right Handrail	12
(83) into the Right Upright. Be careful not to	82		Nuts
pinch the Upright Wire.			Bracket
Orient the Console Frame (102) as shown, with				9
the welded nuts on the bottom. Insert the ends			84
of the Console Frame into the Left and Right				12
Handrails (82, 83). Attach the Console Frame					Welded
with four 1/4" x 1 1/4" Patch Bolts (9) and four				83
1/4" Star Washers (12). Start all four Patch					Nuts
Bolts, and then tighten all of them.				87	85
Lift the Console Frame (102) and the Handrails
(82, 83) off the Uprights (84, 85). Then, pull the				Wire
Upright Wire (87) out of the Right Upright.				Tie
8. Set the console assembly (A) face-down on a	8
soft surface to avoid scratching the console.					3
Attach the Left Accessory Tray (103) with four
#8 x 1/2" Screws (3). Start all four Screws,			A
and then tighten all of them.		3
Attach the Right Accessory Tray (104) in the
same way.			3
					104
		103
	10