3.Identify the Right Upright (85) and the Right Upright Spacer (91), which are marked with “Right” stickers. Align the oval hole in the Right Upright Spacer with the oval hole in the Base
(95).If the holes do not line up, turn the Right Upright Spacer and try again.
Insert the Upright Wire (87) through the Right Upright Spacer (91) as shown. Set the Right Upright Spacer on the Base (95).
Have a second person hold the Right Upright
(85)near the Base (95). See the inset drawing. Tie the wire tie in the Right Upright securely around the end of the Upright Wire (87). Then, pull the other end of the wire tie until the Upright Wire is routed completely through the Right Upright.
4.Hold a Bolt Spacer (14) inside the lower end of the Right Upright (85). Insert a 3/8" x 4 1/4" Patch Bolt (7) with a 3/8" Star Washer (11) into the Right Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (14), 3/8" x 4 1/4" Patch Bolt (7), and 3/8" Star Washer
Hold the Right Upright (85) against the Right Upright Spacer (91). Be careful not to pinch the Upright Wire (87). Tighten the 3/8" x 4 1/4" Patch Bolts (7) until the heads of the Patch Bolts touch the Right Upright; do not fully tighten the Patch Bolts yet.
3
87 |
|
| 85 |
|
Wire Tie | Oval | 87 | 91 | |
|
| Hole |
| |
|
|
| 95 | |
|
|
| Oval | |
|
|
| Hole | |
| 85 |
87 | Wire |
Tie | |
4 | 7 |
| |
| 85 |
| 11 |
| 87 |
| 14 |
| 91 |
8