ProForm PFTL66010.0 Try again. if the Connectors are not, Careful not to pinch any wires

11. Slide the Left Upright Cover (80) onto the Left	11
Upright (84).		84
Slide the Right Upright Cover (86) onto the
Right Upright (85).
		80		85
				86
12. With the help of a second person, hold the con-	12
sole assembly (A) near the Right Upright (85)
and the Left Upright (not shown). Insert the
Upright Wire (87) into the hole in the bottom of	Notch	A
the Right Handrail and out of the end as shown.
Connect the Upright Wire (87) to the console
wire (C). See the inset drawing. The connec-
tors should slide together easily and snap	63
into place. If they do not, turn one connector
and try again. IF THE CONNECTORS ARE NOT	83
CONNECTED PROPERLY, THE CONSOLE	C
MAY BE DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the	87
Upright Wire.
Set the console assembly (A) on the Right	Wire
Upright (85) and the Left Upright (not shown). Be
careful not to pinch any wires.	Tie
Insert the wires into the Right Handrail (83).
Press a Handrail Cap (63) into the end of the			85
Right Handrail and the Left Handrail (not shown).				C
Make sure that the console wire (C) is in the
notch in the right Handrail Cap.				87
	12