JVC RX-7000VBK manual Receiving Radio Broadcasts, Tuning in Stations Manually Using Preset Tuning

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

IMPORTANT:

When using the remote control, check to see if its

remote control mode selector is set to the correct	AUDIO/
	TV/VCR
position:
To operate this receiver, set it to “AUDIO/TV/	CATV/DBS
VCR.”

Tuning in Stations Manually

Using Preset Tuning

Once a station is assigned to a channel number, the station can be quickly tuned. You can preset up to 30 FM and 15 AM stations.

To store the preset stations

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel:

1. Turn SOURCE SELECTOR to select the band (FM or AM).

The last received station of the selected band is tuned in.

2.Press FM/AM TUNING.

3.Turn MULTI JOG until you find the frequency you want.

•Turning it clockwise increases the frequency.

•Turning it counterclockwise decreases the frequency.

•When you turn MULTI JOG quickly, the frequency keeps changing until a station is tuned in.

SOURCE SELECTOR

FM/AM TUNING

MULTI JOG

On the front panel ONLY:

1.Tune in the station you want to preset (see “Tuning in Stations Manually”).

•If you want to store the FM reception mode for this station, select the FM reception mode you want. See “Selecting the FM Reception Mode” on page 19.

2. Press TUNER/SEA MEMORY. TUNER/SEA MEMORY

“CH-” appears and the channel number position starts flashing on the display for about 10 seconds.

MULTI JOG

From the remote control:

1.Press FM/AM to select the band.

•Each time you press the button, the band alternates between FM and AM.

2.Press TUNING UP or TUNING DOWN repeatedly until you find the frequency you want.

•When you hold the button (and release it), the frequency keeps changing until a station is tuned in.

Note:

FM/AM

FF/

TUNING UP

/REW

DOWN TUNING

3.Turn MULTI JOG to select a channel number while the channel number position is flashing.

Note:

You can use the 10 keys on the remote control to select the preset number. When using the 10 keys, be sure that they are activated for the tuner, not for the CD and others. (See page 43.)

4. Press TUNER/SEA MEMORY	TUNER/SEA MEMORY
again while the selected channel
number is flashing on the display.

The selected channel number stops flashing.

The station is assigned to the selected channel number.

When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

When an FM stereo program is received, the STEREO indicator also lights up.

5.Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station

Storing a new station on a used number erases the previously stored one.

18