5. Withthehelpofasecondperson,carefullytipthetreadmillontoitsrightside.Partiallyfoldthe 5 Frame(48)sothetreadmillismorestable;do notfully fold the Frameyet.
Removeanddiscardthetwoindicatedbolts(A) andtheshippingbracket(B).
AttachaBaseFoot(81)totheBase(85)inthelo- cationshownwithaBaseFootSpacer(104)and anM4.2x 25mmTekScrew(2).Then,attachan- otherBaseFoot(81)withonlyaScrew(2).
RemovetheM10Nut(33),theM10x 50mm Bolt(27),andtheshippingbracket(C)fromthe Base(85).AttachaWheel(86)withtheBoltand theNutthatyoujustremovedDonotover.- tightentheNut;theWheelmustturnfreely. Discardtheshippingbracket.
6.Press a Base Cap (82) into the Base (85).
Hold a Bolt Spacer (79) inside the lower end of the Left Upright (73). Insert an M10 x 96mm Bolt
(5)with an M10 Star Washer (8) into the Left Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (79), M10 x 96ram Bolt (5), and M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright Spacer (83) as shown. Hold the Left Upright Spacer and the Left Upright against the Base (85). Partially tighten the M10 x 96mm Bolts (5); do not fully tighten the Bolts yet.
With the help of a second person, tip the tread- mill so that the Base (85) is flat on the floor.
. Set the Console (87) face down on a soft sur- face to avoid scratching the Console. Identify the Right Handrail (90), which has a large hole in the location shown. Hold the Right Handrail near the Console. Attach the console ground wire to the Right Handrail with a #8 x 1/2" Screw (22).
Next, insert the console wire into the large hole in the Right Handrail (90) and out of the top as shown. Attach the Right Handrail with three M4.2 x 19mm Screws (1). Make sure that no wires are pinched. Start all three Screws be- fore tightening any of them; do not over- tighten the Screws.
Attach the Left Handrail (not shown) to the Console (87) in the same way. Note: There are no wires on the left side of the Console.
81
l
2
79
79
82 85
90
Console
Ground
87
85
27
81
C
33
73
Console
Large
Hole