ProForm CS9e user manual Troubleshooting, Problem The power does not turn on

Page 26

TROUBLESHOOTING

Most treadmill problems can be solved by following the instructions below. If further assistance is needed, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 10). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 10. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. Make sure that the key is fully inserted into the console.

c.Check the reset/off circuit breaker located on the frame near the power cord. If the breaker protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the breaker back in.

PROBLEM: The power turns off during use

c

Off Reset

SOLUTION: a. Check the reset/off circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console and then reinsert it.

d.If the treadmill still will not run, please call our Customer Service Department toll-free.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. With the help of another person, carefully tip the Base (109) down as shown. Remove the two 3/4” Screws (6) and the two 3/4” Tek Screws (47). Note: Your treadmill may not have 3/4” Tek Screws. A phillips screwdriver with at least a 5” shaft is required.

With the help of another person, carefully raise the Uprights (69) as shown. Carefully pivot the Hood (39) off.

a

 

6

 

109

47

47

 

39

 

69

69

 

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Customer HOT Line QUESTIONS?Model No. DTL52940 Serial No Table of Contents Important Precautions Page Right Side Before YOU BeginBack Assembly Firmly tighten all three Bolts Bolts, tighten themScrews 6. Be careful not to overtighten the Screws That the Extension Legs 128 remain in the UprightsThat the pin can be inserted fully into the hole. Hold Page Performant Lubetm Walking Belt HOW to Plug in the Power CordTreadmill Operation Features of the Console Select the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key fully into the consoleDistance/Incline dis Tacts. Avoid moving your hands. When yourSpeed display-This Calories/PulseHOW to USE Preset Programs Select one of the preset programsFollow your progress with the displays Enter your age HOW to USE Heart Rate ProgramsSelect a heart rate program Enter a maximum speedFollow your progress with the displays HOW to Connect Your Portable Stereo HOW to Connect Your Home Stereo HOW to Connect Your ComputerPressVCR. the Play button on your CD player or HOW to Connect Your VCRInsert the key into the console Measure your heart rate if desired HOW to USE Programs Directly from OUR WEB Site Follow the on-line instructions to start the programInformation MODE/DEMO Mode HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Troubleshooting Problem The power does not turn onProblem The walking belt slows when walked on Top ViewWorkout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches R1003A Qty DescriptionDescription DTL52940 Exploded Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT HOW to Order Replacement PartsLimited Warranty
Top Page Image Contents