6.Calibrate the screen.
If the screen is not properly calibrated, it will be dif- ficult for you to touch the correct buttons on the screen. To calibrate the screen, touch the Calibrate Screen button and then touch the Begin button. A small target will appear on the screen. Note: Touch the Cancel button to return to the maintenance mode.
Using a pencil eraser or other small object, touch the center of the target. Then, touch the rest of the targets. After several seconds, the console will exit the calibration mode.
Note: If it is difficult to touch the buttons while using the Internet browser, the browser screen should be calibrated. Press and hold the menu button on the console until a + appears on the screen. Using a pencil eraser or other small object, touch and hold the center of the + for a second. Then, touch and hold the rest of the targets. After a few seconds, the console will exit the calibration mode.
7.View technical information.
Touch the Technical Info button to view the total number of hours that the treadmill has been used, the total number of miles that the walking belt has moved, and other information. After you view the information, touch the Finish button.
8.Perform a network test.
Touch the Network Test button to check the con- nection status of the treadmill. The wireless inter- face status shows whether the wireless feature on the treadmill is turned on or turned off. The network access status shows whether the treadmill can connect to your wireless network. The DNS service status shows whether the treadmill can communi- cate with the DNS server. The iFit.com status shows whether the treadmill can communicate with iFit.com. If all the connections are successful, the console will display the word SUCCESS. After you view the information, touch the Finish button.
9.Access the Android™ desktop.
Access the Android desktop only if instructed to do so by an authorized service technician. From the desktop, you can change settings and maintain your console. Touch the Android Desktop button to access the desktop. Press the home but- ton on the console to exit the desktop.
10.Exit the maintenance mode.
To exit the maintenance mode, touch the home button on the screen repeatedly.
HOW TO USE THE STEREO SOUND SYSTEM
To play music or audio books through the consoleʼs speakers, you must connect your MP3 player, CD player, or other personal audio player to the console. Locate the audio wire. Plug one end into the audio jack on the side of the console. Then, plug the other end into a jack on your MP3 player, CD player, or other personal audio player. Make sure that the audio wire is fully plugged in.
Next, press the Play button on your MP3 player, CD player, or other personal audio player. Then, adjust the volume level on your personal audio player or press the Vol increase and decrease buttons on the console. If you are using a personal CD player and the CD skips, set the CD player on the floor or another flat sur- face instead of on the console.
Note: The USB port on the side of the console is for firmware updates only.
28