ProForm PFTL14511.0 warranty Top, Problem The walking belt slows when walked on

Page 31

Locate the Reed Switch (52) and the Magnet (50)

 

 

on the left side of the Pulley (49). Turn the Pulley

 

 

until the Magnet is aligned with the Reed Switch.

 

 

Make sure that the gap between the Magnet and

52

49

the Reed Switch is about 1/8 in. (3 mm). If nec-

essary, loosen the #8 x 3/4" Tek Screw (14), move

14

50

the Reed Switch slightly, and then retighten the

1/8 in.

 

Screw. Reattach the Motor Hood (not shown) and

 

 

run the treadmill for a few minutes to check for a

Top

 

correct speed reading.

 

 

View

 

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. Recalibrate the incline system (see step 3 on page 27).

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 15.

b. If the walking belt is overtightened, treadmill perfor-

b

 

mance may decrease and the walking belt may be-

2–3 in.

come damaged. Remove the key and UNPLUG

 

THE POWER CORD. Using the hex key, turn both

 

 

idler roller bolts counterclockwise, 1/4 of a turn.

 

 

When the walking belt is properly tightened, you

 

 

should be able to lift each edge of the walking belt

 

 

2 to 3 in. (5 to 7 cm) off the walking platform. Be

 

 

careful to keep the walking belt centered. Then,

 

 

plug in the power cord, insert the key, and run the

Idler Roller Bolts

treadmill for a few minutes. Repeat until the walking

belt is properly tightened.

 

 

c. If the walking belt still slows when walked on, see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

 

 

SOLUTION: a. If the walking belt is off-center, first remove the

a

 

key and UNPLUG THE POWER CORD. If the

 

walking belt has shifted to the left, use the hex

 

 

key to turn the left idler roller bolt clockwise 1/2 of a

 

 

turn; if the walking belt has shifted to the right,

 

 

turn the left idler roller bolt counterclockwise 1/2 of

 

 

a turn. Be careful not to overtighten the walking

 

 

belt. Then, plug in the power cord, insert the key,

 

 

and run the treadmill for a few minutes. Repeat

 

 

until the walking belt is centered.

 

 

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents On the WEB QUESTIONS?Model No. PFTL14511.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Instructions Save TheseBefore YOU Begin Wrench Scissors AssemblySee the inset drawing. Tie the wire tie Make sure that the power cord is unpluggedBase Covers into place yet Be careful not to pinch the UprightTighten the Bolts yet. Note It may be helpful Attach the Right Upright not shownAttach the Right Handrail 87 in the same way Shown. Start all four Screws, and then tighten Each of them Important To avoid damagingAgain. if YOU do not Connect the CON Them All four Bolts, and then tighten eachConsole Make sure the caps remain in the ends Storage Latch Page HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console DiagramConsole HOW to SET UP the Console HOW to Turn on the PowerBegin working out HOW to USE the Manual ModeInsert the key into the console Page Turn on the fan if desired Measure your heart rate if desired. Before usingStart the workout HOW to USE AN Onboard WorkoutHOW to USE AN Ifit Live Workout Ifit Live FCC Information HOW to USE the Internet Browser Select the wireless network mode HOW to USE the Settings ModeSelect the unit of measurement Exit the settings modeLog in to your iFit Live account Select a languageSelect the settings mode. See on Select the maintenance mode HOW to USE the Maintenance ModeView technical information HOW to USE the Stereo Sound SystemHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillProblem The power turns off during use TroubleshootingOutlets Top Problem The walking belt slows when walked onTurn if the walking belt has shifted to the right Problem The buttons on the screen do not work correctly Problem The iFit Live mode does not function correctlyExercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part ListQty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Related manuals
Manual 40 pages 31.48 Kb
Top Page Image Contents