ProForm PFTL14511.0 warranty Troubleshooting, Outlets, Problem The power turns off during use

Page 30

TROUBLESHOOTING

Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual. PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 15). Use only a single-outlet surge suppres-

sor that meets all of the specifications described on page 15. IMPORTANT: The treadmill is not

compatible with GFCI-equipped outlets and may not be compatible with AFCI-equipped

outlets.

 

 

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the power switch located on the treadmill

c

 

frame near the power cord. If the switch protrudes

 

as shown, the switch has tripped. To reset the

Tripped

Reset

switch, wait for five minutes and then press the

switch back in.

 

 

PROBLEM: The power turns off during use

 

 

SOLUTION: a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a

store. If the screen shows a demo presentation when you remove the key, the demo mode is

turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the demo

mode is still on, see step 6 on page 26 to turn off the demo mode.

 

 

PROBLEM: The displays of the console do not function properly

 

 

 

SOLUTION: a. Remove the key from the console and UNPLUG

a

 

 

THE POWER CORD. Remove the three #8 x 1/2"

65

1

Screws (1) and the two #8 x 3/4" Screws (2).

 

Carefully pivot the Motor Hood (65) off.

2

 

 

 

 

 

 

 

 

2

30

Image 30
Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. PFTL14511.0 Serial No On the WEBTable of Contents Important Precautions Save These InstructionsBefore YOU Begin Assembly Wrench ScissorsMake sure that the power cord is unplugged See the inset drawing. Tie the wire tieAttach the Right Upright not shown Be careful not to pinch the UprightTighten the Bolts yet. Note It may be helpful Base Covers into place yetAttach the Right Handrail 87 in the same way Important To avoid damaging Shown. Start all four Screws, and then tighten Each of themAgain. if YOU do not Connect the CON All four Bolts, and then tighten each ThemConsole Make sure the caps remain in the ends Storage Latch Page Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Diagram Features of the ConsoleConsole HOW to Turn on the Power HOW to SET UP the ConsoleHOW to USE the Manual Mode Begin working outInsert the key into the console Page Measure your heart rate if desired. Before using Turn on the fan if desiredHOW to USE AN Onboard Workout Start the workoutHOW to USE AN Ifit Live Workout Ifit Live FCC Information HOW to USE the Internet Browser HOW to USE the Settings Mode Select the wireless network modeSelect a language Exit the settings modeLog in to your iFit Live account Select the unit of measurementHOW to USE the Maintenance Mode Select the settings mode. See on Select the maintenance modeHOW to USE the Stereo Sound System View technical informationHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useOutlets Problem The walking belt slows when walked on TopTurn if the walking belt has shifted to the right Problem The iFit Live mode does not function correctly Problem The buttons on the screen do not work correctlyWorkout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart List Key No. Qty DescriptionQty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Related manuals
Manual 40 pages 49.67 Kb