6.Touch the right Handrail (4) to discharge any static.
Hold the Console (11) near the Console Base (87). Insert the Wire Harness (53) through the plastic tie on the bottom of the Console.
Plug the widest connector on the Wire Harness (53) into the widest connector on the Console (11). If the con- nector does not fit easily, rotate it and then connect it. Plug the other connector on the Wire Harness into the other connector on the Console. Note: The locations of the connectors are shown by arrows.
Securely tighten the plastic tie on the Console (11) to prevent the Wire Harness (53) from slipping. Then, cut off the end of the plastic tie.
7.Set the Console (11) in the Console Base (87). Be careful to avoid pinching any wires. Insert the excess Wire Harness (53) into the large hole in the side of the right Handrail (4).
Make sure that no wires are pinched. Tighten seven 3/4” Screws (5) into the Console Base (87) and the Console (11). Do not overtighten the Screws.
Securely tighten the plastic ties on the bottom of the Console Base (87) to prevent the Wire Harness (53) from slipping. Cut off the ends of the plastic ties.
8.Attach the Storage Latch (102) to the left Upright (14) with two 3/4” Screws (5). Be careful not to overtighten the Screws.
Make sure the Upright Endcaps (49) are pressed into the top of the Left Upright (14) and Right Upright (not shown).
6 | 11 |
|
|
| |
| Tie |
|
87 | 53 |
|
4 |
| 53 |
|
| |
7 |
|
|
53 | 87 | 11 |
4 |
|
|
5 | 5 | 5 |
| ||
|
| |
8 |
|
|
|
| 49 |
|
| 14 |
102 |
| 5 |
|
|
7