ProForm PCTL93040 user manual As shown. Do not tighten the Bolts yet

3.	Identify the Right Handrail (72), which has a large hole in	3
	the left side. Feed the Wire Harness (42) up into the
	bracket on the Right Handrail and out of the large hole in		Large		42
	the left side. (Note: It may be helpful to use needlenose
			Hole
	pliers to pull the Wire Harness out of the large hole.)
			Bracket
	Press a Handrail Cap (76) onto the lower end of the				37
	Right Handrail as shown. Remove any plastic ties from				38
	the bracket.		72
	Insert the bracket on the Right Handrail (72) into the top
	of the right Upright (69) so the Handrail Cap (76) is rest-				38
	ing against the Upright. Attach the Right Handrail and the
					37
	Handrail Cap with three 1” Bolts (37) and two Washers
	(38) as shown. Do not tighten the Bolts yet.
					69
					76
			37
4. Attach the Storage Latch (36) and the Latch Spacer (29)		4
	to the Left Handrail (71) with two 1” Latch Screws (123).
	Remove the Latch Knob (30) from the Latch Pin (35).		71
	Make sure that the Latch Pin Collar (33) and the Spring
	(32) are on the Latch Pin as shown. Insert the Latch Pin	29	36
	into the Storage Latch (36) and tighten the Latch Knob
	back onto the Latch Pin.
	Attach the Left Handrail (71) as described in step 3.
	Note: There is not a wire harness on the left side.		30		33
					35
			123		32
5. Attach the end of the ground wire to the small hole in the		5
	side of the Right Handrail (72) with a 1/2” Silver Ground
	Screw (75).
				75	Ground
					Wire
					72

6