ProForm PCTL69030 Console Diagram, Battery Installation, STEP-BY-STEP Console Operation

Page 8

CONSOLE DIAGRAM

Note: If there is a sheet of clear plastic

Clip

on the face of the console, remove it.

 

CAUTION:

Before operating the

 

console, read the following precautions.

 

• Do not stand on the walking belt when

 

turning on the power.

 

 

• Always wear the clip (see the drawing

 

above) while using the treadmill. When the

 

key is removed from the console, the walk-

 

ing belt will stop.

 

 

• Adjust the speed in small increments.

 

• The training zones marked above the

 

speed control are general guidelines only.

 

See page 14 for more information.

 

• To reduce the possibility of electric shock,

 

keep the console dry. Avoid spilling liquids

 

on the console and use only a sealable

 

water bottle.

 

 

 

 

 

BATTERY INSTALLATION

 

 

The console requires three "AA" batteries

(not

included). Alkaline batteries are recommended. Open

 

the battery cover as shown in the drawing at the upper

 

right. Insert the batteries into the battery compartment, making sure that the negative (–) ends of the batteries

Battery

Cover

Tab

Batteries

are touching the springs in the battery compartment. Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown in the inset drawing. Make sure that the tab locks into place.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in (see page 7).

Stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing at the top of this page), and slide the clip onto the waistband of your

clothes. Next, insert the key into the console. Test the clip by carefully taking a few steps backward until

the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Serial Number Decal QUESTIONS?Model No. PCTL69030 Serial No Table of Contents Important PrecautionsNever move the walking belt while the power Move the Treadmill onNever insert any object into any opening Erty damage sustained by or through the use of this productBefore YOU Begin 485For your benefit, read this manual carefully before Right SideAssembly Assembly requires two peopleHandrail Bolt Slide a Handrail Cap 41 onto one of the HandrailsDo not force the connectors together. Next, plug Other Wire into the other connector on the Console BaseImportant Make sure that both Wires are fully insert ScrewsHOW to Plug in the Power Cord TM Walking BeltCould result in damage to the control system This product must be grounded.If it should malSTEP-BY-STEP Console Operation Console DiagramBattery Installation Insert the key fully into the power switch Reset the Speed Control and start the walking beltAdjust the incline of the treadmill as desired Follow your progress with the LED trackHOW to Fold the Treadmill for Storage HOW to Move the TreadmillTreadmill, make sure to lift with your legs rather Mill over an uneven surfaceStorage HOW to Lower the Treadmill for USEBend your legs and keep your back straight Unplug the Power Cord TroubleshootingSolution Problem The incline system does not function properly Problem The walking belt slows when walked onPower Cord Belt has shifted to the leftHOW to Measure Your Heart Rate Conditioning GuidelinesExercise Intensity Workout GuidelinesHOW to Order Replacement Parts Exercise FrequencyLimited Warranty Part No R0803APart LIST-Model No. PCTL69030 Key Qty DescriptionRemove this Exploded Drawing and Part List from the Manual Exploded R0803A
Top Page Image Contents