ProForm DTL92941 user manual Important Precautions

Page 3

IMPORTANT PRECAUTIONS

WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill.

1.It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions.

2.Use the treadmill only as described in this manual.

3.Place the treadmill on a level surface, with at least eight feet of clearance behind it and two feet on each side. Do not place the treadmill on any surface that blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill.

4.Keep the treadmill indoors, away from mois- ture and dust. Do not put the treadmill in a garage or covered patio, or near water.

5.Do not operate the treadmill where aerosol products are used or oxygen is administered.

6.Keep children under the age of 12 and pets away from the treadmill at all times.

7.The treadmill should not be used by persons weighing more than 250 pounds. Never allow more than one person on the treadmill at a time.

8.Wear appropriate exercise clothes when using the treadmill. Do not wear loose clothes that could become caught in the treadmill. Athletic support clothes are recommended for both men and women. Always wear ath- letic shoes. Never use the treadmill with bare feet, wearing only stockings, or in sandals.

9.When connecting the power cord (see page 8), plug the power cord into a surge suppressor (not included) and plug the surge suppressor into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Do not use an extension cord.

10.Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. To purchase a surge suppressor, see your local PROFORM dealer or call 1-888-533- 1333 and order part number 146148.

11.Failure to use a properly functioning surge suppressor could result in damage to the con- trol system of the treadmill. If the control sys- tem is damaged, the walking belt may change speed or stop unexpectedly, which may result in a fall and serious injury.

12.Keep the power cord and the surge suppres- sor away from heated surfaces.

13.Never move the walking belt while the power is turned off. Do not operate the treadmill if the power cord or plug is damaged, or if the treadmill is not working properly. (See BEFORE YOU BEGIN on page 5 if the tread- mill is not working properly.)

14.Never start the treadmill while you are stand- ing on the walking belt. Always hold the handrails while using the treadmill. Never use the Lightspeed bar as a handlebar.

15.The treadmill is capable of high speeds. Adjust the speed in small increments to avoid sudden jumps in speed.

16.The pulse sensor is not a medical device. Various factors, including the user's move- ment, may affect the accuracy of heart rate readings. The pulse sensor is intended only as an exercise aid in determining heart rate trends in general.

17.Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord and switch the reset/off circuit breaker to the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the circuit breaker.)

18.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6, and HOW TO FOLD AND MOVE THE TREADMILL on page 25.) You must be able to safely lift 45 pounds (20 kg) to raise, lower, or move the treadmill.

19.When folding or moving the treadmill, make sure that the storage latch is fully closed.

3

Image 3
Contents QUESTIONS? Model No. DTL92941 Serial NoCustomer HOT Line Table of Contents Important Precautions Page Back Before YOU BeginFor your benefit, read this manual carefully before Right SideAssembly Assembly requires the included allen wrenchAgain. if the Connectors are not Connected As shown. Do not tighten the Screws yet HOW to Plug in the Power Cord Treadmill OperationPerformant Lubetm Walking Belt Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerPace/Time display Distance/Incline disCalories/Pulse Speed display-ThisSelect one of the speed and incline programs HOW to USE Speed and Incline ProgramsFollow your progress with the displays Enter a maximum speed HOW to USE Heart Rate ProgramsSelect a heart rate program Enter your ageFollow your progress with the displays HOW to Create Custom Programs When the program is finished, remove the keySelect one of the custom programs HOW to USE Custom Programs HOW to Connect Your Portable Stereo HOW to Connect Your Computer HOW to Connect Your Home StereoHOW to Connect Your VCR Audio Adapter Cable Insert the key into the consolePressVCR. the Play button on your CD player or Measure your heart rate if desired Follow your progress with the LED track Displays HOW to USE Programs Directly from OUR WEB SiteFollow the on-line instructions to start Program Return to the treadmill and stand on the footInformation MODE/DEMO Mode Optional Chest Pulse Sensor HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesQty Description R0304ADescription Exploded DrawingExploded DRAWING-Model No HOW to Order Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT