JVC FS-L30 Recording on a Tape, Press REC recording, To record on both sides-Reverse Mode

English

Recording

IMPORTANT:

•It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable programme and in any literary, dramatic, musical, or artistic embodied therein.

•The recording level is automatically set correctly, so it is not affected by the other sound settings. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

•If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

•You can use type I tape for recording.

Recording on a Tape

On the unit ONLY:

1 Put a recordable cassette in with the exposed part of the tape down.

To protect your recording Cassettes have two small tabs

on the back to protect from unexpected erasure or re- recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape.

To keep the best recording and playback sound quality

If the heads, capstans, and pinch rollers of the cassette decks become dirty, the following will occur:

•Impaired sound quality

•Discontinuous sound

•Fading

•Incomplete erasure

•Difficulty in recording

To clean the heads, capstans, and pinch rollers

Use a cotton swab moistened with alcohol.

2 Close the cassette holder gently and check the recording direction for the tape.

•If the tape direction is not correct, press TAPE 2 3 twice then 7 to change the tape direction.

•If you want to record on both sides of a tape, see “To record on both sides—Reverse Mode.”

3 Start playing the source—FM, AM or auxiliary equipment connected to AUX jacks.

•When the source is CD, see “CD Direct Recording” on page 18.

4 Press REC (recording). REC

The REC (recording) indicator lights up on the display and recording starts.

To stop recording, press 7.

The tape stops after 4 seconds.

To remove the cassette, press 0 PUSH OPEN on the unit.

Capstans

Heads

Pinch Rollers

To demagnetize the heads

Turn off the unit, and use a head demagnetizer (available at electronics and audio shops).

At the start and end of cassette tapes

There is leader tape which cannot be recorded onto. Thus, when recording CDs or radio broadcasts, wind the leader tape first to ensure that the recording will be made without any music part lost.

To record on both sides—Reverse Mode

Press REV.MODE (reverse mode) until the indicator is lit.

•When using the Reverse Mode for recording, start recording in the forward (3) direction first. Otherwise, recording will stop when recording is done only on one side (reverse) of the tape.

REV.MODE

REV. MODE

– 17 –