4.Connect the Seat Bar Wire (88) to the Handlebar Wire (87).
Slide the Handlebar (7) onto the Seat Bar (6) and attach it with the four Handlebar Screws (51). Make sure you donÕt damage the two Wires as you tight- en the Screws.
Pull both Grips (72) towards the Handlebar (7) until they cover the Handlebar Screws (51).
5.Unscrew the Console Mount Screw (69) and slide the Detent Ring (73) off the shaft on the Console (5).
Slide the console wire through the indicated hole in the Seat Bar (6).
Lubricate the shaft on the Console (5) with the includ- ed grease pack. Slide the shaft into the indicated hole in the Seat Bar (6).
Slide the Detent Ring (73) onto the console shaft and line up the hole in the Ring with the hole in the shaft. Secure the Console (5) with the Console Mount Screw (69). See the inset drawing for more detail.
Plug the console wire into the Seat Bar Wire (88).
6.Attach the Seat (43) to the indicated brackets on the Seat Bar (6) with four M6 x 16mm Seat Screws (28).
Attach the Seat Cover (35) to the Seat (43), using two M4 x 38mm Screws (4) along the rear edge and an M4 x 16mm Tapping Screw (30) on each side.
6
4 |
|
|
| 7 |
|
|
| 72 |
87 | 51 |
|
| 88 |
|
51 |
| 6 |
|
| |
| 72 |
|
5 | 69 |
|
|
| |
Console |
|
|
Wire |
| 6 |
88 |
| |
|
| |
| 73 | 69 |
|
| |
Lubricate |
| 73 |
| 5 |
|
6 |
|
|
|
| 43 |
|
| 6 |
|
| 28 |
|
| 4 |
28 |
|
|
4 |
| 30 |
|
| |
30 | 35 |
|
|
|