Star Trac S-TBT, S-RB, E-RB, S-UB manual Installing Your Universal TV Bracket KIT

Page 7

INSTALLING YOUR UNIVERSAL TV BRACKET KIT

The Star Trac Universal PVS Kit is different for each of your Star Trac E or S Series Cardio products. Make sure you have the proper kit for the E or S Series product you are installing. The E- & S -UB, E- & S-RB, E- & S-TBT, and E- & S-ST will follow the same basic steps for installation.

To install the TV neck on the E-UB, E-RB, and E-TBT, and follow these steps:

STEP1

Using a #2 Phillips screwdriver, to remove the (8) screws on the back of the display plastic. Set the screws aside, you will need them for reassembly.

STEP2

After the screws have been removed, carefully open the display plastic, so as to not detach the inner cables from the display.

Disconnect the ground wire

between the

Heart Rate board and the display mount.

 

STEP3

Disconnect the 12-pin serial connector and the

Heart Rate cable from the display.

After all the cable/harnessing has been disconnected, place the front display plastics aside for later use. Be careful with the display and place it face down on top of a non-scratching surface.

STAR TRAC UNIVERSAL TV BRACKET INSTALLATION

7

Image 7
Contents Installation M a N U a L Table of Contents TBT, RB, and UB Introduction Check Facilities Preparedness Required Tool for Installation Supplied Installing Your Universal TV Bracket KIT Star Trac Universal TV Bracket Installation Star Trac Universal TV Bracket Installation To install the TV neck on the E-TR, follows the se steps Star Trac Universal TV Bracket Installation Star Trac Universal TV Bracket Installation To install the TV neck on the S-TR, follows these steps To install the TV on the bracket follows these steps Star Trac