Star Trac S-RB, E-RB, S-UB, S-TBT manual Star Trac Universal TV Bracket Installation

Page 8

STEP4

Remove the cap cover with the Star Trac logo from the plastics by removing the (2) screws using a #2 Phillips screwdriver. Retain the screws for later use. You will no longer need the cap cover and, if desired, you can store it away for any possible future use.

STEP5

Remove the (2) M8 button head screws retaining the cross brace using the 5mm Hex Key. Found in the hardware kit. Retain the screws for later use. You will no longer need the cross brace and, if desired, you can store it away for any possible future use.

STEP6

Take the TV neck bracket from the package. Install the

(4)M8 Button head Screws through the TV neck bracket into the display mount. Note: (2) of the screws are in the PVS kit, (2) retained from earlier step. Do not tighten them at this time.

STAR TRAC UNIVERSAL TV BRACKET INSTALLATION

8

Image 8
Contents Installation M a N U a L Table of Contents TBT, RB, and UB Introduction Check Facilities Preparedness Required Tool for Installation Supplied Installing Your Universal TV Bracket KIT Star Trac Universal TV Bracket Installation Star Trac Universal TV Bracket Installation To install the TV neck on the E-TR, follows the se steps Star Trac Universal TV Bracket Installation Star Trac Universal TV Bracket Installation To install the TV neck on the S-TR, follows these steps To install the TV on the bracket follows these steps Star Trac