Star Trac E-RB, S-RB, S-UB, S-TBT manual To install the TV neck on the S-TR, follows these steps

Page 13

To install the TV neck on the S-TR, follows these steps:

CAP

STEP1

Using a #2 Phillips screwdriver, to remove the (19) screws from the back of the display. Next, remove the back cover and the upper cap cover with “Star Trac Logo on it (You will no longer need this cap cover and, if desired, you can store it away for any possible future use).

BACK

COVER

SCREWS

STEP2

Take the TV bracket from package and remove the bubble wrap. Insert the bracket into the rectangle tube. Using a 5mm Hex Allen Key to fasten (2) M8 button head screws with (2) washers.

STEP3

Replace the top back cover. Use a #2 Phillips screwdriver insert (19) screws, retained from earlier step, into the plastic cover. Do not tighten now.

Check the Cap with the neck and grommet. Make sure the Cap is flush with the top back plastic, and adjust if necessary. Use the screwdriver to tighten the screws, but don’t over tighten screws

STAR TRAC UNIVERSAL TV BRACKET INSTALLATION

13

Image 13
Contents Installation M a N U a L Table of Contents TBT, RB, and UB Introduction Check Facilities Preparedness Required Tool for Installation Supplied Installing Your Universal TV Bracket KIT Star Trac Universal TV Bracket Installation Star Trac Universal TV Bracket Installation To install the TV neck on the E-TR, follows the se steps Star Trac Universal TV Bracket Installation Star Trac Universal TV Bracket Installation To install the TV neck on the S-TR, follows these steps To install the TV on the bracket follows these steps Star Trac