ProForm 831.28544.0 guide

12. Identify the Left Pedal (13) and the Left Pedal Leg	12			13
(14), which are marked with stickers.	12			13
Attach the Left Pedal (13) to the Left Pedal Leg (14)
with an M4 x 45mm Screw (108), three M4 x 14mm
Screws (104), and four Star Washers (112).
Attach the Right Pedal (not shown) to the Right Pedal
Leg (not shown) in the same way.	112		112	14
	104		108	14
			112	112
13. Apply a thin film of grease to one of the Pedal Leg Axles	13			104
(32) and to the faces of the two Pedal Leg Bushings	13
(33) in the Left Pedal Leg (14).
Next, slide an M8 Washer (88) and a Pedal Leg Cover
(31) onto an M8 x 23mm Shoulder Screw (115), and	11			12
turn the Shoulder Screw a few turns into the Pedal Leg	11		3188	12
Axle (32).		31	3188	115
While another person holds the front end of the Left	88	31		33
Pedal Leg (14) inside of the bracket on the Left Upper	88			33
Body Arm (11), insert the Pedal Leg Axle (32) into both	115		Grease
parts. Next, slide an M8 Washer (88) and a Pedal Leg	115
Cover (31) onto another M8 x 23mm Shoulder Screw	Grease		32
(115), and turn the Shoulder Screw a few turns into the	Grease		32
Pedal Leg Axle. Tighten both Shoulder Screws.
Repeat this step on the other side of the elliptical exer-
ciser.				14
14. Lift the latch on the underside of the Left Pedal Leg	14			14
14. Lift the latch on the underside of the Left Pedal Leg
(14), and set the Left Pedal Leg on the left Crank
Bushing Sleeve (43). Release the lever, and make sure
that the Left Pedal Leg is securely connected to the
Crank Bushing Sleeve.		14
Connect the Right Pedal Leg (not shown) in the same		14
way.			Latch
See step 5. Tighten the M8 x 69mm Button Bolt (80)			Latch	43
See step 5. Tighten the M8 x 69mm Button Bolt (80)
and the two M8 x 23mm Button Screws (84).

15.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.