1.Loosen the Lock Knob (68) on the right side of the Frame (1). Slide the Seat Frame (3) out until it stops. Tighten the Lock Knob.
2.Attach the Upright (2) to the Frame (1) with three M10 x 25mm Button Head Screws (25) and three M10 Split Washers (26). Be careful not to pinch the Reed Switch Wire (13) or the Resistance Cable (10).
3.Route both Extension Wires (41) up through the Upright (2) as shown.
Attach the Handlebar (4) to the Upright (2) with two M6 x 25mm Hex Head Screws (14) and two M6 Split Washers (67), but do not tighten the Screws yet.
Make sure that the Screws are threaded into the indicated holes. Note: Two additional Screws will be attached in step 5.
4.Connect the Reed Switch Wire (13) and the two Extension Wires (41) to the corresponding wires on the Console (8).
Fasten the ground wire to the Upright (2) using an M4 x 16mm Screw (75).
Attach the Console (8) to the Upright (2) with four #8 x 5/8Ó Screws (22).
Press the Resistance Knob (9) onto the Resistance Control (10). Be sure that the mark on the Knob is correctly aligned.
5
1 | 1 |
|
|
|
|
| |
| 68 |
|
|
|
|
| 3 |
2 |
|
|
|
2 |
|
|
|
|
| 25 |
|
26 |
| 26 | |
25 |
| 25 |
|
|
|
| |
| 10 | 13 |
|
|
|
| |
|
| 1 |
|
3 |
|
|
|
|
| 14 |
|
67 | 67 |
|
|
|
|
| |
| 41 |
|
|
14 |
|
| 4 |
2 |
|
|
|
4 | 8 |
|
|
|
| 9 | |
|
|
| |
Console |
|
|
|
Wires |
|
|
|
13 |
| 41 | Ground |
|
|
| |
75 |
|
| Wire |
|
| 10 | |
|
|
| |
22 |
|
|
|
| 2 |
|
|
|
| 22 |
|