2.Locate the Left Upright (5), which has a name decal in the indicated location. Press a 2” x 3” Inner Cap (30) into the Upright.
Attach the Left Upright (5) and a Large Base Foot
(15)to a Stabilizer (3) with two M10 x 93mm Button Bolts (37), an M10 Washer (41), an M10 Nylon Locknut (43), and an M10 Nylon Jamnut (46). Do not tighten the Locknut and Jamnut yet.
Secure the Large Base Foot (15) to the Stabilizer
(3) with an M4 x 16mm Screw (39).
Attach the Left Upright (5) to the Support (6) with two M10 x 93mm Button Bolts (37), two M10 Washers (41), and two M10 Nylon Locknuts (43).
Do not tighten the Locknuts yet.
Repeat this step with the Right Upright (not shown).
Tighten the M10 Nylon Locknuts (43) and the M10 Nylon Jamnuts (46) used in steps 1 and 2.
3.Attach the Crossbar (4) to the Left Upright (5) with two M10 x 68mm Button Bolts (38), a Support Plate (47), and two M10 Nylon Locknuts (43). Do not tighten the Locknuts yet.
Next, attach the Crossbar (4) to the Left Upright
(5)with an M10 x 93mm Button Bolt (37), an M10 Washer (41), and an M10 Nylon Locknut (43). Do not tighten the Locknut yet.
Repeat this step with the Right Upright (not shown).
2 |
|
| 30 |
5 |
|
41 | 43 |
| |
37 | 6 |
| |
41 | 43 |
Name decal | 37 |
on this side |
|
37 |
|
| 3 |
15 | 41 |
| |
| 43 |
46 | 39 |
3 |
|
4 |
|
38 |
|
| 5 |
| 43 |
38 |
|
41 |
|
37 | 43 |
| 47 |
6