Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver			, an adjustable
wrench	, and a rubber mallet	.

See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not found in the parts bag, check to see if it has been pre-assembled.


M8 Nylon	M6 Washer	M8 Split		M8.5 Washer	M10 Split	Wave Washer M10 Washer
Locknut (46)–4	(58)–2	Washer (94)–10		(53)–2	Washer (144)–2	(150)–2		(99)–2
M4 x 16mm	M4 x 16mm Round		M4 x 14mm Round		M4 x 12mm Round			M6 x 16mm Tapered
Screw (66)–12	Head Screw (45)–1		Head Screw (93)–2		Head Screw (18)–2		Button Screw (107)–8


M6 x 18mm Button
M6 x 18mm Button				M8 x 25mm Patch
Screw (67)–4				Screw (22)–2

M8 x 45mm Button

Screw (102)–4

M4 x 52mm Screw (98)–2


M8 x 38mm Button	M8 x 43mm Button
M8 x 38mm Button	M8 x 43mm Button
Screw (70)–2		Bolt (50)–4

M8 x 54mm Button	M10 x 35mm Carriage
Screw (33)–4	Bolt (20)–2
Union Bolt Set (27)–2