HOW TO USE THE ELLIPTICAL EXERCISER
HOW TO EXERCISE ON THE ELLIPTICAL EXERCISER
To mount the elliptical exerciser, hold the handgrip pulse sensor and step onto the pedal that is in the low- est position. Next, step onto the other pedal. Push the pedals until they begin to move with a continuous motion. Note: The pedal discs can turn in either direction. It is recommended that you move the pedal discs in the direction shown by the arrow below; however, for variety, you can turn the pedal discs in the opposite direction.
Handgrip Pulse Sensor |
Handlebars |
Pedals |
Pedal |
Disc |
To dismount the elliptical exerciser, wait until the ped- als come to a complete stop. Note: The elliptical exerciser does not have a free wheel; the pedals will continue to move until the flywheel stops. When the pedals are stationary, step off the highest pedal first. Then, step off the lower pedal.
HOW TO USE THE HANDLEBARS
The handlebars are | Handlebar | Handgrip |
designed to add | ||
| Pulse | |
cise to your work- |
| Sensor |
outs. Push and pull |
| |
the handlebars as |
|
|
you exercise to |
|
|
work your arms, |
|
|
shoulders, and |
|
|
back. |
|
|
To exercise only your lower body, hold the handgrip pulse sensor as you exercise.
HOW TO ADJUST THE STRIDE OF THE ELLIPTICAL EXERCISER
To adjust the stride of the elliptical exerciser, first pull one of the adjustment knobs until the adjustment bracket can be pivoted freely. Then, pivot the adjust- ment bracket until the adjustment knob is aligned with either of the two holes in the crank arm, and gently release the knob. Pivot the adjustment bracket back and forth slightly to make sure that the adjustment pin is engaged in one of the holes. Adjust the other side of the elliptical exerciser in the same way.
Crank |
|
Arm |
|
Holes |
|
Pin |
|
Adjustment | |
Adjustment | Bracket |
Knob |
|
11