3.Slide an M10 Split Washer (94) onto each of the two M10 x 83mm Button Screws (63). Insert the Button Screws into the Front Stabilizer (3). Next, slide the Mast (15) onto the Button Screws and against the Front Stabilizer. Make sure that the Mast is oriented as shown.
While another person holds the Mast (15) and the Front Stabilizer (3) near the Frame (1), connect the Extension Wire Harness (95) to the Lower Wire Harness (87). Insert the connectors on the Wire Harnesses into the Mast.
While the other person lifts the front of the Frame (1), carefully pull the upper end of the Extension Wire Harness (95) to remove any slack. While holding the upper end of the Extension Wire Harness, attach the Mast (15) and the Front Stabilizer (3) to the Frame with the two M10 x 83mm Button Screws (63).
Do not tighten the Button Screws yet.
Be careful to avoid pinching the Wire Harnesses (87, 95) during this step.
4.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (86) to the Extension Wire Harness (95).
Next, insert the Upright (2) into the Mast (15); make sure that the Upright is oriented as shown. Attach the Upright with two M8 x 70mm Button Bolts (67), two M8 Split Washers (83), and two M8 Nylon Locknuts (46). Be careful to avoid pinching the Wire
Harnesses (86, 95) during this step. Do not tighten the Button Bolts yet.
Attach the Water Bottle Holder (72) to the Upright (2) with two M4 x 22mm Screws (76).
3 | Pull |
| Avoid pinching the |
|
| ||
|
|
| |
|
|
| wire harnesses |
|
|
| during this step |
|
| 15 |
|
3 |
|
| 95 |
| 63 | 94 | 871 |
|
| ||
|
|
|
4 | Avoid pinching the | |
| wire harnesses | |
| during this step | |
2 |
| 72 |
|
| |
|
| 76 |
86 |
|
|
95 | 83 |
|
46 |
| 67 |
Hexagonal | 83 | |
Holes |
| |
| 15 |
|
7