4.The Console (7) requires two "AA" batteries (not included). Alkaline batteries are recommended. Refer to the inset drawing. Remove the battery door from the Console. Press two batteries into the bat- tery compartment. Make sure that the negative ends of the batteries (marked ÒÐÓ) are touching the springs in the battery compartment. Reattach the battery door.
Connect the console wire to the Reed Switch Wire (33).
Slide the Console (7) onto the console plate. Note: The Console attaches by friction; it does not snap into place.
5.Insert the Seat Post (10) into the Frame (1). Press the Frame Bushing (40) into the Frame. Align one of the holes in the Seat Post with the hole in the Frame. Insert the Seat Pin (35) through the Frame and the Seat Post to select the desired seat height.
Make sure to insert the Seat Pin through one of the holes in the Seat Post; do not insert the Seat Pin under the Seat Post.
Next, attach the Seat (11) to the Seat Post (10) with one M8 x 50mm Carriage Bolt (36) and one M8 Nylon Locknut (39).
6.Identify the Left Pedal (21). (The Left Pedal is marked with an ÒL.Ó) Using an adjustable wrench, tighten the Left Pedal counterclockwise into the left arm of the Crank (20).
Tighten the Right Pedal (not shown) clockwise into the Right arm on the Crank.
4 |
| |
7 |
| |
33 |
| |
Console | Console | |
Plate | ||
Wire | ||
| ||
| Batteries | |
| Battery Door | |
5 |
| |
| 11 | |
36 | 39 | |
| ||
10 |
| |
40 | 35 | |
| 1 | |
6 |
| |
| 20 | |
21 |
|
7.Make sure that all parts are properly tightened before you use the exercise cycle.
5