3.Find the Left Pedal (31), which has a ridge on the right side. Attach the Left Pedal to one of the Pedal Arms (12) with three M4 x 19mm Round Head Screws (16) as shown.
Repeat this step to attach the Right Pedal to the other Pedal Arm (not shown).
4.Locate the Left Handlebar (8) (there is an ÒLÓ sticker on the Left Handlebar for identification). Apply a thin film of the included grease to the axle at the lower end of the Left Handlebar.
Slide a Handlebar Spacer (39) and the Pedal Arm
(12)with the Left Pedal (31) onto the Left Handlebar
(8)as shown. Make sure that there are two Pedal Arm Bushings (42) in the Pedal Arm. (Note: These parts fit tightly; it may be helpful to use the rubber mallet). Next, refer to the PART IDENTIFICATION CHART on page 5 and identify the 3/4Ó Axle Caps
(43).Tap a 3/4Ó Axle Cap onto the Left Handlebar.
Repeat this step to attach the other Pedal Arm (12) to the Right Handlebar (62).
5.Slide a Weld Spacer (49) onto the left axle on the Upright (3). Make sure that the open side of the Weld Spacer is facing the Upright.
Apply a thin film of the included grease to the axles and crank arms in the locations indicated.
Slide a Pedal Arm Spacer (41) onto the left Crank Arm (59).
Make sure that there are two Rear Pedal Arm Bushings (11) in the Pedal Arm (12) attached to the Left Handlebar (8).
With the help of another person, slide the Left Handlebar (8) onto the left axle on the Upright (3) while sliding the left Pedal Arm (12) onto the left Crank Arm (59). Note: These parts fit tightly; it may be helpful to use the rubber mallet. In addition, it may be helpful to rotate the left Crank Arm (59) to a different position.
Tap a 5/8Ó Axle Cap (57) onto the left axle on the Upright (3).
Tap a 3/4Ó Axle Cap (43) onto the left Crank Arm (59).
Repeat this step to attach the Right Handlebar and the right Pedal Arm (not shown).
3
Ridge
31
12
16
4
62
8
12
39
42
43
Grease
12
31
5
57 | Grease |
49
8
3
Grease
59
41
11 |
12
43
7