11.Identify the Left Pedal (22), which is marked with an “L.” Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the Left Crank Arm (24). Tighten the Right Pedal (not shown) clockwise into the Right Crank Arm. Important: Tighten both
Pedals as firmly as possible. After using the exer- cise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tight- ened.
Adjust the Left Pedal Strap (25) to the desired posi- tion, and press the end of the Pedal Strap onto the tab on the Left Pedal (22).
Adjust the Right Pedal Strap (not shown) in the same way.
12.Plug one end of the Power Cord (52) into the jack at the front of the exercise cycle. Plug the other end of the Power Cord into an appropriate outlet that is prop- erly installed in accordance with all local codes and ordinances. Note: In the UK, use the included adapter (not shown) with the Power Cord.
Note: The console can be operated with batteries instead of the Power Cord (52) if desired. To install batteries, follow the instructions below.
See the inset drawing. Press the indicated tab on the battery drawer and pull the battery drawer down. Press four “D” batteries into the battery clips; make sure that the batteries are oriented as shown by the markings inside of the battery clips. Then, close the battery drawer. Note: Alkaline batteries are recommended.
11 |
|
25 | 24 |
| |
Tab | 22 |
12 |
|
52 |
|
| 4 |
| Batteries |
Battery |
|
Drawer |
|
Tab |
|
13.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
9