ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the | |||
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the | |||
included allen wrenches, assembly requires a phillips screwdriver | , an adjustable | ||
wrench | , and a rubber mallet | . |
|
Refer to the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 22. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been
M6 Large | M8.5 Small | M8.5 | M10 Split |
Washer | Washer | Washer | Washer |
Wave Washer | M10 Nylon | M4 x 16mm | M4 x 22mm |
Locknut | Screw | Screw | |
M6 x 16mm Button | M6 x 45mm Flat | M8 x 19mm Patch | M8 x 25mm Patch |
Screw | Screw | Screw | Screw |
| M10 x 112mm Carriage Bolt |
| |
| M10 x 85mm Button Screw |
|
5