ProForm PFEL54932 specs

9.Apply a small amount of the included Teflon® lubricant to a paper towel. Rub a thin film of the lubricant onto the Handlebar Legs (79). Next, identify the Left Handlebar (9) and the Right Handlebar (10), which are marked with stickers. Slide the Left Handlebar onto the left Handlebar Leg, and slide the Right Handlebar onto the right Handlebar Leg. Make sure that the

Handlebars are on the correct sides—the upper ends should bend in the direction shown.

Apply a generous amount of grease to the Pivot Axle

(88).Insert the Pivot Axle into the Right Handlebar (10) and a Handlebar Spacer (25) as shown. Next, insert the Pivot Axle into the Upright (2) until the left end of the Pivot Axle is flush with the left side of the Upright. Then, insert the Pivot Axle through the other Handlebar Spacer (25) and the Left Handlebar (9).

Make sure that the Handlebar Spacers are turned so the small arrows are pointing toward the floor. Slide an M8.5 Washer (53) and a Wave Washer (116) onto each of the two M8 x 25mm Patch Screws (22). Tighten the Patch Screws into the ends of the Pivot Axle (88) at the same time. Then, press the tabs on the two Handlebar Caps (23) into the Handlebar Spacers (25).

Tighten the M10 x 85mm Button Screw (63).

10.Attach the Water Bottle Holder (91) to the Upright

(2)with two M4 x 22mm Screws (93).

9			10
			10
			Grease 22 23
			88
9	25		25 116 53
23 53116			2
23 53116	Arrow	79	Lubricate
22	Arrow		63
22			63
			79
Lubricate
10
			91
			93
			2