How to Move the Incline Trainer
Before moving the incline trainer, change the grade of the incline trainer to the lowest level and unplug the power cord.
1.Hold the handrails as shown and place one foot against the walking belt.
2.Tilt the incline trainer back until it rolls freely on the wheels. The help of a second person may be helpful when tipping the trainer. Carefully move the trainer to the desired loca- tion. Never move the trainer without tipping it back. To reduce the risk of injury, use extreme caution while moving the trainer. Do not attempt to move the trainer over an uneven surface.
3.Place one foot on the walking belt, and carefully lower the incline trainer until it is resting on the floor.
Wheels |
Trouble-shooting
Most problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c.Check the circuit breaker located on the incline trainer near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
d.Check the on/off switch located on the incline trainer near the power cord. The switch must be in the on position.
c
Tripped | Reset |
d
On
Position
20