ProForm PFHK99902 user manual Tighten all of the bolts used in steps 4

3.Identify the right Upright (23), which has the Upright Wire Harness (100) inside of it.

Have a second person hold the right Upright (23) near the Base Wire Harness (41) on the right side of the Base (101). Connect the Upright Wire Harness (100) to the Base Wire Harness (41). Make sure that the two connec- tors snap together. Pull the excess Upright Wire Harness out of the top of the right Upright.

Slide the right Upright (23) onto the Base (101). Be care- ful not to pinch the Wire Harnesses (41 and 100).

4.Finger tighten two Long Upright Bolts (54) into the right Upright (23) and the Base (101) as shown. Next, finger tighten two of the four 1” Upright Bolts (33) with two of the four Internal Star Washers (32) into the right Upright. Do not tighten the Bolts yet.

Attach the left Upright (not shown) in the same way. (Note: There is not a wire harness in the left Upright.) Do not tighten the Bolts yet.

5.Have a second person hold the Handrail (27) near the Uprights (23). Refer to the inset drawing. Slide an O-ring (117) onto each Upright (23). Connect the Handrail Wire Harness (30) to the Upright Wire Harness (100). Make sure that the two connectors snap together. Insert the Wire Harnesses into the Handrail (27) and the right Upright (23).

Slide the Handrail (27) onto the Uprights (23). Be care- ful not to pinch the Wire Harnesses (30 and 100).

Finger tighten two Handrail Bolts (25) with Handrail Star Washers (26) into each side of the Handrail (27). Note: If the Handrail Bolts do not line up with the holes in the Uprights (23), roll the O-rings (117) onto the thicker parts of the Uprights. After the Handrail has been attached, roll the O-rings over the joints where the Handrail and the Uprights meet.

Tighten all of the bolts used in steps 4 and 5.

3	23
	100
		41
		101
4		33
		32
	33
		23
		101
54	23
5
		27
26
25		26
23	23
		25
27
23
117	30
	100

6.Make sure that all parts are tightened before you use the incline trainer. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 22). To protect the floor or car- pet from damage, cover the floor beneath the trainer.

7