2Ó Upper Screw First | ProForm PFMC77754 instruction

5. See figure 5a. Before you begin this step,	Fig. 5a
make sure that the Right Hub Cover (19) is	Fig. 5a
make sure that the Right Hub Cover (19) is
attached to the Top Frame (2) with a rubber
band as shown. If the Right Hub Cover has
come off during shipping, see figure 5b.		2
Slide the Right Hub Cover onto the Right		2
Slide the Right Hub Cover onto the Right
Pivot Bracket (20).		Rubber Band
		Rubber Band
See figure 5a. Find the two holes inside the slot	Note: Tighten the	Hole
of the Right Hub Cover (19). Make sure that the	Note: Tighten the	Hole
rubber band is not covering the holes, and that	2Ó Upper Screw		19
rubber band is not covering the holes, and that	(25) first.		19
the holes are aligned.	(25) first.
the holes are aligned.
See figure 5a. Hold the Right Leg (7) against	25
See figure 5a. Hold the Right Leg (7) against		Hole
the Right Hub Cover (19). Thread the 2Ó Upper	26	Hole
the Right Hub Cover (19). Thread the 2Ó Upper	26
Screw (25) two complete turns into the upper
hole inside the Right Hub Cover. Thread the
2 1/4Ó Lower Screw (26) two complete turns			7
into the lower hole. Break and remove the rub-			7
into the lower hole. Break and remove the rub-
ber band.
See figure 5a. Fully tighten the 2Ó Upper Screw	Fig. 5b
See figure 5a. Fully tighten the 2Ó Upper Screw
(25). After the 2Ó Upper Screw is tightened, fully
tighten the 2 1/4Ó Lower Screw (26).
Repeat assembly steps 3, 4, and 5 to attach	ÒRIGHTÓ
Repeat assembly steps 3, 4, and 5 to attach	Sticker
the Left Leg and the Left Handle (not shown) to	Sticker	20
the Left Leg and the Left Handle (not shown) to		20
the left side of the AIR WALKER.
	19
6. See figure 6a. Insert two ÒAAÓ batteries (not includ-	Fig. 6a
ed) into the Monitor (39). Alkaline batteries are	Fig. 6a
ed) into the Monitor (39). Alkaline batteries are	Batteries	39
recommended. Make sure that the negative (Ð)		39
recommended. Make sure that the negative (Ð)
ends of the batteries are touching the springs,	40
and that the positive (+) ends of the batteries
are pushed against the metal contacts.
See figure 6a. Plug the Reed Switch Wire (44)		Fig. 6b	40
See figure 6a. Plug the Reed Switch Wire (44)
into the Monitor (39). Insert any excess wire into			39
the Console (40).			39
the Console (40).	44
	44
See figure 6b. Snap the Monitor (39) into the
Console (40). Be careful not to pinch the wire
between the Monitor and the Console.

Before you use the AIR WALKER, use the included allen wrench to firmly re-tighten all of the screws used in assembly. Remove the orange and green identification stickers from the AIR WALKER. Note: During the first few minutes that the AIR WALKER is used, a squeaking noise may be heard. This is normal during the break-in period.

2Ó Upper Screw

(25) first.