8. Apply a small amount of grease to the axle on the left | 8 |
|
|
| ||
Disc Crossbar (16). Slide a Spring Spacer (63) onto the |
|
|
| |||
|
|
|
| |||
axle; make sure that the Spring Spacer is turned so |
|
| Grease |
| ||
the flat side is facing the elliptical crosstrainer. |
|
|
| |||
|
|
|
| |||
Next, slide the Left Rear Spring Bracket (12) on the left |
|
|
| 16 | ||
Pedal Spring (11) onto the axle. | Slide a Spring Br | acket |
|
| ||
Washer (35) onto an M10 x 27mm Patch Screw (40), | 11 |
|
| 63 | ||
and tighten the Patch | Screw into the axle. |
|
| |||
|
| 12 |
| |||
|
|
|
|
|
| |
Next, hold the lower end of the left Handlebar Leg (5) | 40 | 35 |
| 2 | ||
inside of the Front Spring Bracket (65) on the left Pedal |
|
|
|
| ||
Spring (11). Apply grease to an M10 Bolt Set (25). |
|
|
|
| ||
Attach the Handlebar Leg to the Front Spring Bracket |
|
|
|
| ||
with the Bolt Set. | Do not overtighten the Bolt Set; |
|
|
| 5 | |
the Handlebar Leg must pivot freely. |
|
|
|
|
| |
Attach the right Pedal Spring (not shown) to the right |
|
|
|
| ||
side of the elliptical crosstrainer in the same way. | Grease |
| 65 | 25 | ||
Refer to step 5. Tighten the M10 x 74mm Bolts (7) in |
|
|
| |||
|
|
|
| |||
the Upright (2). |
|
| 25 |
| 11 |
|
|
|
|
|
| ||
|
|
|
|
|
| |
Refer to step 6. Tighten the M8 x 45mm Button Bolts |
|
|
|
| ||
(50) in the Handlebar Legs (5). |
|
|
|
|
| |
9. Make sure that all | parts of the elliptical crosstrainer are properly tightened. | Note: Some hardware may |
be left over after | assembly is completed. To protect the floor or carpet from damage, place a mat under the |
|
elliptical crosstrainer. |
| |
8