Seiko Y182 Alarm engagement Alarm disengagement, Pull out to first click, Push back in to normal

Page 9

ALARM ENGAGEMENT/DISENGAGEMENT

• Alarm engagement		• Alarm disengagement
CROWN 2	Pull out to first click.	CROWN 2	Push back in to normal
			position.

English

	11	12	1				11	12	1
	11		1				11		1
	10			2			10		2
Designated	9			3	➠		9		3
	A L A R M					Current time	A L A R M
	7	6	5	4		Current time	7	6	5
	8						8
alarm time									➠
	[Alarm engaged]								➠
	[Alarm engaged]						[Alarm disengaged]

NOTES

1Alarm rings at the designated time for 20 seconds.

*To stop it manually, press Button A, B or C, or push CROWN 2 back in to normal position.

2If CROWN 2 is pulled out to second click, the designated alarm time is canceled with a warning beep.

*In that case, set ALARM hands to MAIN TIME again, push CROWN 2 back in to normal position, and then, pull it out to first click and set the desired alarm time again. However, if CROWN 2 is pushed back in to normal position before the warning beep stops, the designated alarm time will not be canceled.

9

Image 9

Contents Page Contents Seiko Analogue Quartz FeaturesThere are three buttons and two crowns Display and CROWNS/BUTTONSCrown Date SettingWhen setting Hour hand, check that AM/PM is correctly set Time SettingAdjustment of Alarm hands AlarmTion Alarm time settingAlarm engaged Alarm disengaged Alarm engagement Alarm disengagementPull out to first click Push back in to normalStopwatch Operation StopwatchStart Stop Finish Time 2ND Competitor Reset To measure the hourly average speed of a vehicle TachymeterTo measure the hourly rate of operation Adjusting the Hand Position Resetting the BUILT-IN IC Battery Change Battery Life IndicatorEnglish