Activate Surround or DSP Mode | JVC TH-A35 specification

To turn off the sounds temporarily

From the remote control ONLY:

Press MUTING.	MUTING
To restore the sound, press MUTING again.
• Pressing AUDIO VOL + or – also restores the sound.

6 Activate Surround or DSP Mode

You can enjoy Dolby Pro Logic II mode and DSP modes.

Dolby Pro Logic II—Pro Logic II Movie and Pro Logic II Music

To activate Pro Logic II modes

Press SURROUND.

SURROUND

The current Pro Logic II mode appears on the display for a while.

•Each time you press the button, Pro Logic II mode changes as follows:

PL II MUSIC PL II MOVIE

PL II OFF

• When Dolby Pro Logic II mode is activated, the PRO LOGIC

II indicator lights up on the display.

–For in-depth information about Dolby Pro Logic II modes, see “Creating Realistic Sound Fields” on pages 19 to 21.

DSP modes—CONCERT, STADIUM, HALL,

THEATER, LIVE HOUSE

To activate DSP modes

Press DSP.

DSP

The current DSP mode appears on the display for a while.

•Each time you press the button, DSP mode changes as follows:

LIVE HOUSE HALL CONCERT

DSP OFF THEATER STADIUM

–For in-depth information about DSP modes, see “Creating Realistic Sound Fields” on pages 19 to 21.

Note:

Before activating the Surround or DSP mode, adjust the speaker setting to bring out the best performance from this system.

For in-depth information about adjusting the speaker setting, see “Setting Menu” on pages 55 and 56.

7 Stop Playback

Press 7 twice.

Playback stops completely.

• This system can memorize the end point even when you press 7 once. When you start playback again by pressing 3, playback begins from where it has been stopped—Resume play.

To remove the loaded disc

Press 0.

“OPEN” appears on the display and the disc tray comes out.

To close the disc tray, press 0 again.

To prohibit disc ejection

On the front panel ONLY:

Press and hold 6 and 4 for more than 3 seconds.

“LOCKED” appears on the display, and the disc tray is locked.

To cancel the prohibition, press and hold

6and 4 for more than 3 seconds. “UNLOCK” appears on the display, and the disc tray is unlocked.

To turn off the power (into standby)

Press AUDIO

(or

AUDIO

STANDBY/ON on the front panel).

The illumination lamp goes off and the STANDBY lamp lights up.

•If you press AUDIO (or STANDBY/ON on the front panel) while the disc tray is kept open, the disc tray closes automatically, then the system is turned off.

•A small amount of power is consumed even in standby mode. To turn the power off completely, unplug the AC power cord.