Seiko 7K52 manual Precautions for Diving, Before Diving

Page 20

English

20

PRECAUTIONS FOR DIVING

BEFORE DIVING

Check that:

the watch operates normally.

the crown is locked tightly in place.

there are no visible cracks in the crystal or the watch band.

the strap or bracelet is securely fastened to the watch case.

the buckle keeps the strap or bracelet firmly secured to the wrist.

the time and date are properly indicated.

the small second hand is moving at one-second intervals.

the log data of the previous two dives is recalled properly.

all the hands for diving measurement are reset to “0” position.

While the small second hand is moving at two-second intervals, or when the DEPTH hand points to the 58-minute position after all the hands are reset to “0” position, the watch will not measure the depth. In these cases, replace the battery with a new one. (See “BATTERY LIFE INDICATOR”)

If there are any malfunctions, do not use the watch for diving. We recommend that you contact an AUTHORIZED SEIKO SERVICE CENTER.

If the temperature of the water is much lower than the air temperature (for example, if the watch is put into water after it is left in direct sunlight for a long time), the watch may not measure the depth accurately. In this case, soak the watch in water for approximately 5 minutes before starting to dive.

If the watch is used in places where atmospheric pressure or temperature changes sharply,

Image 20
Contents Cal K52 English English English Contents TIME/CALENDAR SINGLE-TIME AlarmDiving Measurement Crown Screw lock type Small second handHOW to USE the Screw Lock Type Crown To unscrew the crown To screw in the crownTIME/CALENDAR Setting Adjusting the Hand Position Before Diving Press repeatedly until you hear a long beepHOW to Read the Measurements Diving MeasurementHOW to USE the Diving Function Press button B repeatedlyCase Rapid ascent warningRapid Ascent Warning Beep BeepExtra Measurement Range Warning Limit Abnormal Measurement / Measurement Halt WarningEnglish Recall of LOG Data Log data of the last diveLog data of the dive before last Diving hands at PositionRotating Bezel SINGLE-TIME Alarm Alarm Time SettingPrecautions for Diving Before DivingWhile Diving After Diving TIME/CALENDAR Setting Adjusting the Hand Position Before DivingExtra measurement range warning How to read the measurementsHow to use the diving function Remarks on the indication of MAX.DEPTH and Depth hands Recall of LOG DataAbnormal measurement / measurement halt warning SINGLE-TIME Alarm Battery Life Indicator Battery ChangeEnglish Necessary procedure after battery change HOW to USE the Diver Extender To extend the band lengthSpecifications Accuracy of the alarm ± 1 minute