STEP 3 (See Diagram 3)
A.) | Attach the Seat Bracket (#6) to the pivot on the Sliding Block (#5). Push two ∅ ¾” x |
| 3/8” Bushings (#53) through the holes on the Seat Bracket into both ends of the pivot. |
B.) | Attach the Backrest Supports (#12) to the Bushings. Secure it with one M10 x 7 ¼” |
| Hex Bolt (#42), two ∅ ¾” Washers (#39), and one M10 Aircraft Nut (#40). |
C.) | Attach the Backrest Incline Support (#11) to the Backrest Supports (#12). Secure it |
| with a M10 x 7 ¼” Hex Bolt (#42), two ∅ ¾” Washers (#39), and one M10 Aircraft Nut |
| (#40). |
D.) | Attach the other end of Backrest Incline Support (#11) to the open bracket on the Main |
| Seat Support (#4). Secure it with one M10 x 3 3/8” Allen Bolt (#44), two ∅ ¾” |
| Washers (#39), and one M10 Aircraft Nut (#40). |
E.) | Use the Sliding Block to select desired Backrest Incline position. NOTE: Do not over |
| tighten the Bolts and Nuts. Make sure the Backrest Supports are able to incline. |
| DIAGRAM 3 |
6