JVC UX-S57 manual Maintenance, Cleaning the unit, Stains on the unit, To clean the disc

Page 28

Maintenance

To get the best performance of the unit, keep your discs clean.

General Notes

Handling discs

In general, you will have the best performance by keeping your discs clean.

• Store discs in their cases, and keep them in cabinets or on shelves.

Cleaning the unit

• Stains on the unit

Should be wiped off with a soft cloth. If the unit is heavily stained, wipe it with a cloth soaked in water-diluted neutral detergent and wrung well, then wipe clean with a dry cloth.

• Since the unit may deteriorate in quality, become damaged or have its paint peel off, be careful about the following:

–DO NOT wipe it with a rough cloth.

–DO NOT wipe it too vigorously.

–DO NOT wipe it with thinner or benzine.

– DO NOT apply any volatile substance such as an insecticide to it.

– DO NOT allow any rubber or plastic to remain in contact with it for a long time.

•Remove the disc from its case by holding it at the edge while pressing the center hole lightly.

•Do not touch the shiny surface of the disc, or bend the disc.

•Put the disc back in its case after use to prevent warping.

•Be careful not to scratch the surface of the disc when placing it back in its case.

•Avoid exposure to direct sunlight, temperature extremes, and moisture.

To clean the disc

Wipe the disc with a soft cloth in a straight line from center to edge.

DO NOT use any solvent—such as conventional record cleaner, spray, thinner, or benzine—to clean

the disc.

25

Image 28

Contents Instructions Important for Laser Products Above ALL Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront panel Display window on the front panel Display windowRemote Control See pages in parentheses for detailsConnecting Antennas Before connecting it, disconnect the supplied FM antennaGetting Started UnpackingConnecting Speakers Release your finger from the clampAM MW antenna To connect speakersConnecting Other Equipment Putting the Batteries into the Remote ControlTo remove the speaker grilles To connect audio equipmentSetting the Clock On the remote control onlyOn the remote control only Press CLOCK/TIMER Press Disc UP or Disc Down to adjust the minute, then pressTurning On the Power To turn off the unit automatically Auto StandbyAdjusting the Volume On the remote controlReinforcing the Bass Sound On the unitAdjusting the Tone Changing the Display BrightnessPresetting Stations Tuning in to a StationListening to FM and AM MW Broadcasts Press SET again Tuning in to a Preset StationStored appears on the display for a while Changing the RDS Information Receiving FM Stations with RDSSearching for Programs by PTY Codes PTY Search Switching Temporarily to a Program Type of Your Choice Type you want flashes on the displayWait for about 3 seconds after specifying the data type To activate the Enhanced Other Networks functionWhen playing CD-Rs or CD-RWs About the disc indicatorsPlaying Back Discs on the 5-CD Changer Loading DiscsPlaying Back All the Entire Discs -Continuous Play To go to another track directly using the number buttons Basic Disc OperationsTo select a group or track before playback MP3 discs only To locate a particular point in a track during playPrograming the Track Playing Order -Program Play Playing at Random-Random Play Repeating Tracks or Discs-Repeat PlayProhibiting Disc Ejection CD Random appears on Display Using the Timers Using the Daily TimerPress STANDBY/ON to turn off Unit if the unit is on Adjust the clock if neededPlay Using the Sleep Timer On the remote control only Press SleepHow the Sleep Timer actually works Sleep indicator lights up on the displayMaintenance Cleaning the unitTo clean the disc Stains on the unitSymptom Possible Cause TroubleshootingAction Additional Information Description of the PTY codesSpecifications UX-S57 Micro Component System