STEP 2 (See Diagram 2)
A.) Slide 14 Weight Plates (#33) onto the Guide Rods. Make sure the deep groove on the Weight Plates all facing the front of the machine and downward. Insert the Selector Rod (#28) through the center hole on the Weight Plates. Slide the Selector Stem (#32) onto the Guide Rods. Use the
B.) Place the Upper Frame (#5) onto the Vertical Frame (#4). Secure them with one M10 x 2 ¾” Allen Bolt (#75), two Ø ¾” Washers (#80), and one M10 Aircraft Nut (#82) from the side. One M10 x 2 ¾” Allen Bolt (#75), one 1 7/8” Square Bracket (#25), two Ø ¾” Washers (#80), and one M10 Aircraft Nut (#82) from front.
C.) Attach the holes on the Top Socket Assembly (#6) onto the two Guide Rods (#7). Secure it with two M10 x 1” Allen Bolts (#71) and two Ø ¾” Washers (#80).
D.) Attach the other end of Top Socket Assemble to the Upper Frame. Secure it with one M10 x 2 ¾” Allen Bolts (#75), one M10 x 2 ½” Allen Bolt (#74), two Ø ¾” Washers (#80), one 4” x 2” Bracket (#24), one Ø ¾” Washer (#80), and one M10 Aircraft Nuts (#82).
E.) Attach the Weight Stack Cover (#27) to Rear Base Frame (#2) and Top Socket Assembly. Secure it with four M10 x 5/8” Allen Bolts (#70) and four Ø ¾” Washers (#80).
F.) Securely tighten all Nuts and Bolts previously installed in
10